PANASONIC HH 700/900 NOTES: This is a dual NAM hand held unit. The ESN prefix is 136 decimal & 88 hex. Panasonic: 1-800-922-0028 NAM PROGRAMING: 1. Turn power on. 2. Within 20 seconds enter * 0 # 0 * 0 # 0 * 1 FCN ALPHA for NAM 1 or * 0 # 0 * 0 # 0 * 2 FCN ALPHA for NAM 2. 3. Each data entry can be looked at by pressing RCL followed by the location (step) number below. 4. To store new data enter the value, press STO followed by the location (step) number below. For example to enter a system ID of 00031 enter 00031 STO 01. Data can be entered or reviewed in any order. 5. At any time press STO * * to complete programing. 6. Press END to exit. PROGRAMING DATA: STEP# #OF DIGITS/RANGE DISPLAY DESCRIPTION 01 00000 - 32767 SIDH SYSTEM ID 02 10 DIGITS OWN DIAL MIN (AREA CODE & TEL NUMBER) 03 0 OR 1 PRESYS PREFERRED SYSTEM 04 333 OR 334 IPCH INITIAL PAGING CHANNEL 05 2 DIGITS ACCOLC ACCESS OVERLOAD CLASS 06 2 DIGITS GIM GROUP ID (10 IN USA) 07 2 TO 4 DIGITS LOCK CODE LOCK CODE 08 8 DIGIT, 0 OR 1 FCN 1 SEE NOTE 1 BELOW. 09 8 DIGIT, 0 OR 1 FCN 2 SEE NOTE 2 BELOW 10 NOT USED NOT USED 11 UP TO 12 DIGITS EMERGENCY EMERGENCY NUMBER NOTES: 1. Suggested entry is: 11100000. Bit 7/Digit 1 = Local use Mark Bit 6/Digit 2 = MIN Mark Bit 5/Digit 3 = Allow user A/B system select Bit 4/Digit 4 = Not Used Bit 3/Digit 5 = Not Used Bit 2/Digit 6 = Not Used Bit 1/Digit 7 = Not Used Bit 0/Digit 8 = Not Used 2. Suggested entry is: factory default. Bit 7/Digit 1 = Built in Monitor Bit 6/Digit 2 = Battery save mode Bit 5/Digit 3 = DTMF Bit 4/Digit 4 = Not Used Bit 3/Digit 5 = Not Used Bit 2/Digit 6 = Not Used Bit 1/Digit 7 = Not Used Bit 0/Digit 8 = Not Used LOCK: F 3 1 lock code, +/- toggles mode. UNLOCK: Enter two to four digit code. A/B SYSTEM SELECT: F 7 2, then +/- to select, STO to store.