from drwho@l0pht.com FOR AUTHORIZED DEALER USE ONLY NOKIA 101/1000/N201/211/191 CELLULAR HANDPORTABLE TELEPHONE NAM PROGRAMMING INSTRUCTIONS The Nokia 101 series handportable CMT uses an EEPROM NAM that can be programmed directly from the standaard user keypad. In order to access the NAM, you must enter the special access code currently programmed into the phone. This code can be changed and therefore may vary from phone to phone. Once the programming mode is accessed, NAM parameters are loaded by entering them into the display and "storing" them in selected memory locations. Be sure to obtain all parameters before proceeding. ACCESS NAM PROGRAMMING MODE: 1. Turn the phone on. 2. Enter the NAM access code. Factory default is: * 3 0 0 1 # 1 2 3 4 5 3. Enter [STO] 00. 4. Verify that "STORE NOT DONE" appears in the display. If "NOT ALLOWED" appears, check to see if you have entered the access code correctly. Note: If the correct access code is unknown, reprogramming must be referred back to the wholesale purchaser of the phone. ENTER SPECIAL NAM PARAMETERS (Memory Location 01): 5. Press and hold the [CLR] key until the display clears. 6. In one long string, enter the special NAM parameters according to the format of Example 1 below. Enter each emergency number (such as 911 or *911) followed by the pound (#) key, the Language Code followed by the asterisk (*) key, and the desired four digit lock code. Language code: 0 = English, 1 = French, 2 = Spanish. EXAMPLE 1: 9 1 1 # * 9 1 1 # 0 * 1 2 3 4 7. Enter [STO] 01 [STO]. ENTER MOBILE PHONE NUMBER (Memory Location 02 or 04): 8. Press and hold the [CLR] key until the display clears. 9. Enter the correct 10 digit phone number. 10. If desired, press the [ALPHA] key and enter a name of up to 16 characters. Note that the zero (0) key can be used to insert a blank space. After the name is entered, press [ALPHA]. 11. (For Primary NAM) Enter [STO] 02 [STO]. (For Optional NAM) Enter [STO] 04 [STO]. ENTER SYSTEM PARAMETERS (Memory Location 03 or 05): 12. Press and hold the [CLR] key until the display clears. 13. In one long string, enter the system parameters according to the format of Example 2 below. Be sure to separate each parameter with an asterisk (*). Do not place and asterisk before or after the string. Initial Paging Channel_________ \ System ID ______ \ ___Access Overload Class \ / \ / /\ / \ / \ EXAMPLE 2: 3 4 * 1 * 1 * 3 3 4 * 1 5 * 1 5 / \ \/ Access Method Local Use Mark \__Group ID Mark 14. (For Primary NAM) Enter [STO] 03 [STO]. (For Optional NAM) Enter [STO] 04 [STO]. VERIFY NAM INFORMATION: 15. Press and hold the [CLR] key until the display clears. 16. Enter [RCL] followed by one of the memory locations from above (01 through 05). 17. Verify that the information for that memory location is correct. 18. To exit the programming mode, power the phone off then back on. If "NAM ERROR" or NO SVC appears on the display, programming was done incorrectly and must be repeated. -END .