GENERAL ELECTRIC CF1000, 2000, 2500, 3000XR, 3500XR, 4500XR NOTES: Some of these phones have dual NAMS. The ESN prefix is 146 decimal, 92 hex. General Electric: 1-800-528-7711 NAM PROGRAMING: 1. Press any key to turn power on. 2. Within 10 seconds press and hold the CL key while entering 9 2 3 8 8 5. 3. If this does not work try pressing and holding the FCN key, press 4, release FCN, press the volume up key twice, press CLR, release and immediately press and hold CLR while entering 9 2 3 8 8 5. 4. Most phones will display the ESN in decimal format at this stage, some will step directly to programming step 0. 5. The S (send) key is used to store each item and increment the step number. 6. The END key is used to complete and exit programing mode at any time. PROGRAMING DATA: STEP# #OF DIGITS/RANGE DESCRIPTION 0 10 DIGITS MIN (AREA CODE AND TEL#) 1 000 TO 999 LOCK CODE (MUST BE DIFFERENT THAN STEP 11) 2 00000 - 32767 SYSTEM ID 3 0 OR 1 LOCAL USE MARK 4 0 OR 1 MIN MARK 5 333 OR 334 INITIAL PAGING CHANNEL 6 2 DIGITS ACCESS OVERLOAD CLASS 7 0 OR 1 PREFERRED SYSTEM 8 2 DIGITS GROUP ID (10 IN USA) 9 0 OR 1 HORN ALERT 10 0, 1 OR 2 HANDS FREE (SEE NOTE 1 BELOW) 11 3 DIGITS ALT LOCK CODE (MUST BE DIFFERENT THAN STEP 1) If the phone has dual NAMS it will display "0" or "1", press 1 to program second NAM. Single NAM units will display NAM step 0 (MIN), you can scroll through your entries by pressing S (send), press END to complete. NOTES: 1. Set to "1" for normal hands free option. Set to "2" if the phone is equipped with "Hands Free II" option T4JB06, this will allow the volume control on the speaker to be used. LOCK: Hold END/FCN and press 7. UNLOCK: Enter three digit code. SYSTEM SELECT: Hold END/FCN and press 4, display will show current mode: 0 = Pref/Non pref, 1 = Pref only, 2 = Home only, 3 = Non home only, 4 = Non pref/pref, 5 = Non pref only. Use volume to scroll to desired option, then press CL.