File 1/1 By: CšLWater "How to Make a StunGun" PARTS THAT YOU WILL NEED (Go to your local radio shack): All resistors are 1/2 watt.Abbrv. as R1 or R2. ---------------------------------------------- R1 & R2 100,000 ohm's resistors! R3 & R4 500,000 ohm's resistors! ---------------------------------------------- DIODES:D1-D4 Use a 75 PIV BRIDGE RECTIFIER or 4 1N9004's 300 VOLTS. ---------------------------------------------- Capacitors: C1&C2 4700uF electrolytic ---------------------------------------------- TR1-STEP UP TRANSFORMER 55 uH AUDIO ---------------------------------------------- 2 250 volt AC DPST switch ---------------------------------------------- A 9volt RECHARGEABLE/100 volt Neon lamp =L ---------------------------------------------- A 9volt battery clip/MALE-FEMALE RCA JACKS ---------------------------------------------- Some perf board,wire,solder ---------------------------------------------- 9volts in - + / to RCA JACK / |---* *-------------| Use RCA JACK TO HOOK TO A RECHARGER. | sw2 | Run JACK FROM 9V. |----|<-----|<------| | d1 d2 | When battery runs down Recharge it! |----|<-----|<------| | d3 d4 | | | \ / / R1 \ R2 \ / | + | |----|(-------------| | c1 | \ \ / / \ \ | R3 - | R4 |----|(-------------| | c2 L Neon charge light/ Push sw1 to fire when light is on |/ | * *---------| | sw1 | | + n - ======= /\/\/\/ TR1 ======= | | needles or prods | | \|/ \|/ When this is built hold down sw2 until neon lamp lights. Then Stick it into your victim. And press SW1 ,He will get a jolt. To shock mass amounts of people, go to your local swimming pool or beach, and make sure there are NO LIFEGUARDS around. Tape down sw2 and sw1 and throw it in the water all victims, including possible sealife will be electrocuted, and possibly killed. Make a hundred of them and throw them into an ocean... (-eof-) (c)nXo/loteknologies