Easter Egg Bomb with delay fuse By FootMaan email: 0101@geocities.com Disclaimer: The intention of this text is of educational value only. Creation of such a device can cause great bodily harm or even death. Use this information at your own risk. Equipment: (1) Large easter egg (larger half holds 1/3 of a cup; smaller one holds 1/4) (1) Cigarette (1) Fast burning fuse (1 1/2 inches) (1) Paper towl (1) Drill with small bit (1) Explosive powder (black powder / solidox / etc.) (1) Super glue (1) Thin role of masking tape Instructions: In the smaller half of the egg, drill a small hole in the top. This hole will help air circulate whitin the egg and help the cigarette's smoke get out. Next, take the larger half of the egg and pour ~ 1/3 of a cup (or till full) of explosive powder in it. Now, Glue around the edge of the larger half and place the paper towl on top of were you glued making sure the paper towl is taught; then cut the exess away from the egg. This will help the powder from igniting prematurely if the cigarette comes near and keep the the powder in the larger half of the egg. Now, Put a small hole large enough for the fuse to fit through in the towl then put the fuse in the hole and making sure the bottom of the fuse reaches the powder beneath the paper towl. Next, take the cigarette and cut the filter off (make sure the cigarette can fit horrizantaly inside the smaller half of the egg by cutting the exess off also) and put a hole for the fuse on the far end of one side of the cigarette; then carefully fit the fuse through the hole you made and make sure there is a little bit of the fuse sticking out from the other side of the cigarette. Now, take the tape and tape the upper part of the fuse (the part sticking out on other side of the cigarette) to the cigarette. Usage: To use, simply light the oppisite end of the cigarette the fuse has been placed on and carefully put the smaller half of the egg back onto the larger one. Even though I said earlier that the paper towl might protect the cigarette from igniting the explosive powder prematurely, the egg should be placed on its side so gravity will not force the cigarette onto the partition between the explosive powder and the cigarette (the paper towl) just to be safe. After the cigarette has burned down to the place were you put the fuse through, the fuse should ignite and several seconds later the fuse should ignite the powder causing the egg to explode. I am not aware of the length of time required for this to happen because I have never built one of these before but I hope to some time in the futer. Explosives: Finding explosive powder required to build an egg bomb is easy; you can buy gun powder at a gun store or make some type of powder at home. To make a solidOx explosive folow these inscructions: If you baught solidOx pellets, just mix 1/6 of a cup with 1/6 of a cup of table sugar. If you are using sticks, grind them up with a morder and pestal to create powder then mix 1/6 of a cup with 1/6 of a cup of table sugar. After this, the mixture will be ready to be put in the egg. SolidOx can be baught at most hardware stores and some stores like Kmart.