Making Your Very Own Bong That You Can ReUse By PHiSH Making a Bong is really easy... :) Materials Needed: 1: 1/4" aluminum tubing (that's 1/4" on the outside... not the inside) (Make sure this is ALUMINUM tubing an NOT COPPER, Heating copper tubing and inhaling the fumes can kill you!!) 2: Glass Bottle with fitting lid or double holed stopper (holes must be 1/4") 3: Drill + 1/4" Drill Bit OR 1/4" punch 4: 1/4" Socket for a Socket Wrench, best to use the biggest size you can find that still fit's the 1/4" wrench 5: Fine screen, like the one you'd use in a pipe, available at most bong/pipe selling stores Procedure: 1: Drill two 1/4" holes in the lid 2: Cut about 4" (depending on the size of your bong) of Al. tubing 3: Curve the 4"'s os tubing to 90 degrees 4: Put the lid with the holes onto the glass bottle 5: Put the 4" Curved piece of tubing into one of the holes 6: Straighten the rest of the tubing and put it into the other hole 7: Slide the big piece of tubing all the way down so it touches the bottom 8: Curve the bottom of the Big piece just a tad 9: Cut the top of the big peice of tubing about 1" or 2" above the cap 10: Put the screen in the big side socket 11: Put the socket on the end of the big tube 12: Pull the tube assembly out of the bottle and fill the bottle about half full with water 13: Obtain some Marijuana and smoke it Picture (As best I can draw it) __ \ |_| _|_|_ | | | | | | | | / | \ | | | <----Water Fill Level | | | | \ | ^^^^^^^^^