SEAGATE TECHNOLOGY, INC. 1-800-SEAGATE http://www.seagate.com (C)opyright 1996 ST-423451W Ultra-SCSI Wide (Elite 23) J01 WD models have J7 ÚÄ Terminator Power Source (see below)ÄÄ¿ here (see below)Ä¿ 2o³o4 ³ J4A ³ 1o o3 J4B ³ o o o o o o A R o o ³ Power o o o o ³ o o o o o o g F o o * ___________________ Ú12ÄGÄGÄ5Ä¿ o o o o ³ Í1ÍØÍØÍØÍØÍØÍÍØÍØÍØÍÍØÍÍÍ( ×××××××××××××××××1)ÍÍÍÍ͵ 0 0 0 0 ÆÍ1ÍØÍØÍØÍÍ ³ 8 4 2 1 ³ ³ ÃÄÙ ³ ³ \ÄÄÄÄÄÄÄÄÄÄÄijÄÄÄÄ/ \ÄÄÄÄÄÄÄÄÄ/ ³ ³ ³ ³ ³ ÄÄÄÂÄÄÄ ³ ³ ³ ³ ³ SCSI Cable Connector 68-pin ³ ³ ³ ³ ³ ³ ³ ³ ³ ³ ³ ³ ³ ³ ³ ³ ³ ³ ³ ³ ³ ÀÄÄ Spindle Synch Cable Connector ³ ³ ³ ³ ³ ³ ³ ³ ³ ³ (top pin: SSREF, bottom: ground) ³ ³ ³ ³ ³ ³ ³ ³ ³ ÀÄÄÄÄÄ Terminator Enable (N&W models only) ³ ³ ³ ³ ³ ³ ³ ³ ÀÄÄÄÄÄÄÄÄÄ LED Connection (g: ground pin) ³ ³ ³ ³ ³ ³ ³ ³ Activity (A-g), Ready (R-g), ³ ³ ³ ³ ³ ³ ³ ³ Fault (F-g) ³ ³ ³ ³ ³ ³ ³ ÀÄ Reserved ³ ³ ³ ³ ³ ³ ÀÄÄÄ Write Protect Enable Spinup Delay ÄÙ ³ ³ ³ ³ ÀÄÄÄÄÄÄÄÄ SCSI ID (12 secs * ID) ³ ³ ³ ³ Motor Start option enable ÄÄÄÙ ³ ³ ³ Parity check DISable ÄÄÄÄÄÙ ³ ³ Reserved ÄÄÄÄÄÄÄÙ ³ ÕÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ͸ ³ ³ Terminator Power Source Options ÃÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÙ ÃÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÁÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ¿ ³ 1 & 2 Ä Drive supplies power for its own terminator resistor-paks ³ ³ but not to SCSI Bus. This is the factory setting. ³ ³ 2 & 4 Ä Initiator supplies power over the SCSI Bus for terminators. ³ ³ Drive supplies no terminator power. ³ ³ 1 & 3 ³ ³ AND Ä Drive supplies power for external terminator at end of the ³ ³ 2 & 4 daisy chain. Terminator resistor-paks must be disabled. ³ ³ This option is recommended only for last drive on daisy ³ ³ chain. ³ ÀÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÙ ST423451WD drives do not have internal terminators or any other way of adding internal terminators to the drive. Use external differential termination when required. ÚÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ¿ ³ * J7 Auxiliary remote cable connection (from above) ³ ÀÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÙ o o o o o R1 Wide Differential ONLY 12o o o o g F2 <<-- pins 4, 6, 8, 10, 12 are ground ØÍØÍØÍØÍØÍØÍ 8 4 2 1 ÃÄÙ ÄÄÄÂÄÄÄ ³ ³ ÀÄÄ LED Connection (g: ground pin-4) ³ Ready (R-g), Fault (F-g) ÀÄÄÄÄÄÄÄ SCSI ID ST-423451W Elite 23 UNFORMATTED CAPACITY (GB) ________________29.6 FORMATTED CAPACITY (GB) __________________23.2 AVERAGE SECTORS PER TRACK ________________237 (rounded down) ACTUATOR TYPE ____________________________ROTARY VOICE COIL TRACKS ___________________________________192,528 CYLINDERS ________________________________6876 HEADS ____________________________________28 DISCS (5.25 in) __________________________14 MEDIA TYPE _______________________________THIN FILM HEAD TYPE ________________________________MR RECORDING METHOD _________________________ZBR PRML (0,4,4) INTERNAL TRANSFER RATE (mbits/sec) _______86 to 124 INTERNAL TRANSFER RATE AVG (mbyte/sec) ___ EXTERNAL TRANSFER RATE (mbyte/sec) _______40 (burst) SPINDLE SPEED (RPM) ______________________5,400 AVERAGE LATENCY (mSEC) ___________________5.55 COMMAND OVERHEAD (mSEC) __________________<0.5 BUFFER ___________________________________2048 Kbyte Read Look-Ahead, Adaptive, Multi-Segmented Cache INTERFACE ________________________________Ultra-SCSI Wide ASA2 BYTES PER TRACK (avg UNF) ________________152,908 SECTORS PER DRIVE ________________________45,322,643 BYTES PER CYLINDER _______________________ TPI (TRACKS PER INCH) ____________________5555 BPI (PEAK KBITS PER INCH) ________________125.3 AVERAGE ACCESS (ms) read/write ___________13.2/14.2 SINGLE TRACK SEEK (ms) read/write ________1.3/2.3 MAX FULL SEEK (ms) read/write ____________28.2/28.2 MTBF (power-on hours) Class A Room _______NA MTBF (power-on hours) Office _____________800,000 SHOCK (G's, 11/2 ms): operating (Read/Write) __________2 abnormal ________________________7.5 nonoperating ____________________40/ ACOUSTICS (Bels typical, sound power) ____4.6 POWER DISSIPATION (watts/BTUs) Active ____ Idle ______24/82 POWER REQUIREMENTS: Single-ended/Differential +12V START-UP (amps) _4.8/4.8 +12V TYPICAL (amps) __1.6/1.6 +5V START-UP (amps) __1.0/1.05 +5V TYPICAL (amps) ___.9 TYPICAL ( watts seek/read)_27.2 IDLE (watts) ______________22 USER MANUAL PART NUMBER __________________ ** Already low-level formatted at the factory with 6 cylinders per region and 82 spares per region. Physical: Height (inches/mm): 3.25/82.6 Width (inches/mm): 5.75/146.1 Depth (inches/mm): 8.0/203 Weight (lbs/kg): 7.0/3.17 Seagate reserves the right to change, without notice, product offerings or specifications. (04/15/98)