SEAGATE TECHNOLOGY, INC. 1-800-SEAGATE http://www.seagate.com (C)opyright 1996 ST-3425A, Filepro 425 AT (Cabo CFS425A) ÉÍÍÍÍÍÍÍÍÍÍÍ» º REAR VIEW º ÈÍÍÍÍÍÍÍÍÍÍͼ J2 40 pin I/O Optional Mini Power Cable Connection Power Connector ³ ÚÄÁÄ¿ ÕÍÍÍÍÍÍÍÍÍ ÍÍÍÍÍÍÍÍ͸ G 5 /ÄÄÄÄÄÄÄÄÄ\ TOP (HDA) ͵::::::::::ú::::::::1Æ͵0 0 0Æͳ 0 0 0 0 ³ÍÍ ÔÍÍÍÍÍÍÍÍÍͳÍÍÍÍÍÍÍÍ; 12 ÀÄ5ÄGÄGÄ12Ù BOTTOM ³ ÀÄÄÄ pin-20 removed ST-3425A ÉÍÍÍÍÍÍÍÍÍÍÍÍÍÍ» º Front View º ÈÍÍÍÍÍÍÍÍÍÍÍÍÍͼ ÚÄÄÄÄ Not Used ³ ³ ÚÄÄ Master ON, Slave OFF (C/D) ³ ³ (TOP) o o o o o o o1 Option Block ÍÍÍo o o o o o o2ÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ (BOTTOM) ÀÄÄÄÂÄÙ ³ ³ ³ Reserved ÄÄÄÙ ³ Cable Select ÄÄÄÄÙ ST-3425A Filepro 425 AT (Cabo CFS425A) FORMATTED CAPACITY _______________________425 ACTUATOR TYPE ____________________________VOICE COIL CYLINDERS __PHYSICAL______________________3687 HEADS ______PHYSICAL______________________2 DISCS (3.5 in) ___________________________1 MEDIA TYPE _______________________________THIN FILM HEAD TYPE ________________________________THIN FILM RECORDING METHOD _________________________ZBR RLL (1,7) INTERNAL TRANSFER RATE (Mbits/sec) _______29.9 to 55.2 EXTERNAL TRANSFER RATE (Mbytes/sec) ______up to 16.6 PIO MODE _________________________________4 DMA SUPPORT ______________________________EISA Type B SPINDLE SPEED (RPM) ______________________3600 AVERAGE LATENCY (mSEC) ___________________8.33 BUFFER ___________________________________64K Read/Write Multiple, Read Look-Ahead, Multi-Segmented INTERFACE ________________________________ATA SECTORS PER DRIVE (LBA mode) _____________ TPI (TRACKS PER INCH) ____________________3845 BPI (KBITS PER INCH) _____________________77K AVERAGE ACCESS (ms) ______________________14 SINGLE TRACK SEEK (ms) ___________________3 MAX FULL SEEK (ms) _______________________26 MTBF (power-on hours) Office _____________300,000 SHOCK (G's): operating (Read/Write) __________5 abnormal ________________________ nonoperating ____________________75 ACOUSTICS (bels) (typ/max) _______________38/ POWER DISSIPATION (watts) ________________ POWER REQUIREMENTS: +12V START-UP (amps) _ POWER MANAGEMENT (Watts): ACTIVE _______________4.5 IDLE _________________3.0 STANDBY ______________<1.0 WRITE PRECOMP (cyl) ______________________N/A REDUCED WRITE CURRENT (cyl) ______________N/A LANDING ZONE (cyl) _______________________AUTO IBM AT DRIVE TYPE ________________________* Physical: Height (inches/mm): 1.00/25.4 Width (inches/mm): 4.00/101.6 Depth (inches/mm): 5.75/146.1 Weight (lbs/kg): 1.3/0.59 * MAY REQUIRE FORMATTING AND PARTITIONING SOFTWARE. ALSO, CHECK TO SEE IF YOUR CMOS SETUP HAS A "CUSTOM" OR "USER DEFINABLE" DRIVE TYPE AVAILABLE. (see below) Possible translations: 839 cyl, 16 heads, 62 sectors = 426,131,456 Note: A "custom" or "user-definded" CMOS drivetype may ask for a numerical value for the Write Precompensation cylinder and for the Landing Zone cylinder. A basic rule-of-thumb for drive models that do not require the old Write Precomp technique or a Landing Zone because they are Auto-Parking is to add 1 to the cylinder value being used. As an example: If cylinders equaled 820, then both Write Precomp and Landing Zone would be entered as 821. Some BIOS will convert this to 65535 or -1, which are functionally equivalent to "none (not used)". Already low-level formatted at the factory. Since a User-definable or Custom translation geometry may be used, it is imperative that the values be written down and kept with your permanent records for retrieval in the event of CMOS battery failure. Seagate reserves the right to change, without notice, product offerings or specifications. (02/19/96)