SEAGATE TECHNOLOGY, INC. 1-800-SEAGATE http://www.seagate.com (C)opyright 1997 ST-33232A (Medalist 3232 Ultra ATA-3) ÉÍÍÍÍÍÍÍÍÍÍÍ» º REAR VIEW º ÈÍÍÍÍÍÍÍÍÍÍͼ J2 40 pin I/O Cable Connection ³ pin-20 removed ³ ÕÍÍÍÍÍÍÍÍÍ ³ÍÍÍÍÍÍÍÍÍÑÍÍÍÍÍ1Í/ÄÄÄÄÄÄÄÄÄ\ TOP (HDA) ͵::::::::::ú::::::::1³ : : : ³ 0 0 0 0 ³ÍÍ ÔÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÏͳͳͳÍÀÄ5ÄGÄGÄ12Ù BOTTOM ³ ³ ³ Master ON, Slave OFF ÄÙ ³ ³ Slave Present (when Master ON) ÄÄÄÄ´ ³ Cable Select (when Slave OFF) ÄÄÄÄÙ ³ Reserved ÄÄÄÄÄÄÙ o o 1o o ³ ³ Limit capacity to 2.1 Gbytes ÄÄÄÙ ³ (4092 cylinders) ³ Full capacity (as shipped) ÄÄÄÄÄÙ Limit Capacity jumper sets the default cylinder translation to 4092 to solve issues with certain BIOS that only auto-detect. Total available sectors are still at full capacity as reported via Identify Drive data words 52 - 61. Third party partitioning software may be needed to achieve full capacity if this option jumper is used. ST-33232A Medalist 3232 AT FORMATTED CAPACITY (MB) __________________3227 ACTUATOR TYPE ____________________________VOICE COIL CYLINDERS __PHYSICAL______________________ HEADS ______PHYSICAL______________________6 DISCS (3.5 in) ___________________________3 MEDIA TYPE _______________________________THIN FILM HEAD TYPE ________________________________THIN FILM RECORDING METHOD _________________________ZBR 2/3 (1,7)RLL INTERNAL TRANSFER RATE (Mbits/sec) _______up to 87.8 EXTERNAL TRANSFER RATE (Mbytes/sec) ______up to 33.3 PIO/DMA/UDMA MODE (max) __________________4/2/2 DMA SUPPORT ______________________________EISA Type B SPINDLE SPEED (RPM) ______________________4500 AVERAGE LATENCY (mSEC) ___________________6.67 BUFFER ___________________________________128K Read/Write Multiple, Read Look-Ahead, Multi-Segmented INTERFACE ________________________________Ultra ATA-3 SECTORS PER DRIVE (LBA mode) _____________6,303,024 TPI (TRACKS PER INCH) ____________________5950 BPI (KBITS PER INCH) _____________________115.1 AVERAGE ACCESS (ms seek/read/write) ______12/12.5/14.5 SINGLE TRACK SEEK (ms seek/read/write) ___2/2.5/3.5 MAX FULL SEEK (ms seek/read/write) _______21.5/22/23 MTBF (power-on hours) Office _____________300,000 SHOCK (G's): operating (Read/Write) __________5 abnormal ________________________ nonoperating ____________________75 ACOUSTICS (bels) (typ/max) _______________3.7/4.6 POWER DISSIPATION (watts) ________________ POWER REQUIREMENTS: +12V START-UP (amps) _1.8 POWER MANAGEMENT (Watts): ACTIVE _______________6.6 IDLE _________________4.8 STANDBY ______________1.0 WRITE PRECOMP (cyl) ______________________N/A REDUCED WRITE CURRENT (cyl) ______________N/A LANDING ZONE (cyl) _______________________AUTO IBM AT DRIVE TYPE ________________________* Physical: Height (inches/mm): 1.03/26.2 Width (inches/mm): 4.03/102.4 Depth (inches/mm): 5.78/146.8 Weight (oz/g): 19.04/540 * MAY REQUIRE FORMATTING AND PARTITIONING SOFTWARE. ALSO, CHECK TO SEE IF YOUR CMOS SETUP HAS A "CUSTOM" OR "USER DEFINABLE" DRIVE TYPE AVAILABLE. (see below) Possible translations: This translation is generally acceptable, as is, for non-DOS operating systems: 6253 cyl, 16 heads, 63 sectors = 3,227,148,288 DOS operating systems may require a translation that uses larger values for the CMOS head parameter which lowers cylinders below 1024: 781 cyl, 128 heads, 63 sectors = 3,224,567,808 Other FULL-CAPACITY solutions for DOS operating systems include third-party drive preparation software, system BIOS which supports LBA mode or bios driven host adapters. Otherwise, capacity may be limited to: 1024 cyl, 16 heads, 63 sectors = 528,482,304 Some systems BIOS have capacity limitations. Types that have been identified are: a 2.113GB or 4095 cylinder limitation a 3.262GB or 6322 cylinder limitation and, if exceeded, may cause the system to hang during boot, or it can truncate or wrap the cylinders when auto-detect options set in the CMOS. DOS cannot access more than 2.147 Gbytes per partition. Create two partitions to access the drive's full capacity. Note: A "custom" or "user-definded" CMOS drivetype may ask for a numerical value for the Write Precompensation cylinder and for the Landing Zone cylinder. A basic rule-of-thumb for drive models that do not require the old Write Precomp technique or a Landing Zone because they are Auto-Parking is to add 1 to the cylinder value being used. As an example: If cylinders equaled 820, then both Write Precomp and Landing Zone would be entered as 821. Some BIOS will convert this to 65535 or -1, which are functionally equivalent to "none (not used)". Already low-level formatted at the factory. Since a User-definable or Custom translation geometry may be used, it is imperative that the values be written down and kept with your permanent records for retrieval in the event of CMOS battery failure. Seagate reserves the right to change, without notice, product offerings or specifications. (02/05/98)