Bad Ass Retards Presents -"Plastic Tube Bombs"- by Trillion I came a across this idea while looking around a Rockaway Sales hardware store for a suitable pipe for a pipe bomb. I came across this plastic tubing. It was bendable, yet was not too thin. I decided to see what I could do with it. I decided that this would be suitable for a bomb that could get into "hard to reach places" and bend around corners for tight fighting spaces. I got about 6 inches of it. I yanked a fuse out of a pipe bomb because I didn't feel like making them, but virtually any fuse would be fine. I melted some wax from the bottom of a candle onto the "mouth" of the tube. This formed a half circle. TTTTTT T - Tube TTTTTT T T w - Wax TwwwwwwT TwwwwwwwwT F - Fuse TwwwFFwwwT TwwwwwwT TwwwwwwT TTTTTT TTTTTT Then I placed the fuse on top of the half circle and melted a little more wax onto it to seal it. I left about 1 1/2 inches of fuse in the tube. Then I sealed of the rest of the opening. Then I poured some blackpowder into the other end. Until it was about halfway full. Then I stuffed tissue paper into it until it was pretty tight. Then I could have either used more wax or sealed a cap onto it. You could have also sealed a cap onto the fuse section, but I was too lazy. Now this cannot bend at 90 degree andgles but it is still good for a fair curve. Just remember to pack it tightly and to have sturdy endcaps. Have fun! - /Trillion\ BAR '93