Blowgun by The Jolly Roger


In this article I shall attempt to explain the use and manufacture

of a powerfull blow-gun and making darts for the gun.The possesion of

the blow gun described in this article IS a felony.

So be carefull where you use it. I don't want to get you all busted.

 

Needed:

 

1. Several strands of yarn (About 2 inches a-piece)

2. A regular pencil

3. A 2 1/4 inch long needle (hopefully with a beaded head. If not

obtainable,wrap tape around end of needle.

4. 2-3 1/4 foot pipe. (PVC or Aluminum) Half a inch in diameter

 

Constructing the dart:

 

1st- Carefully twist and pull the metal part (Along with eraser)

of the pencil till it comes off.

2nd- Take Pin and start putting about 5-7 Strands of yarn on the pin. Then

push them up to the top of the pin. But not over the head of the pin (orthe tape).

3rd- Push pin through the hollow part of the head where the pencil was before.

4th- That should for a nice looking dart. (see illustration)

 

#####

>>>>>-----/ # is the yarn

> is the head of the pencil

- is the pin it-self

/ is the head of the pin

 

Using the Darts:

1st- Now take the finished dart and insert it in the tube

(if it is too small put on more yarn.)

2nd- Aim the tube at a door, wall, sister, ect.

3rd- blow on the end of the pipe.

4th- Sometimes the end of the pipe may be sharp. When this happens I

suggest you wrap it with some black electrician tape.It should feel

a lot better.

-= Exodus =-